Suport plutitor pentru placă de surf Insta360 Floating Surfboard Mount

Descriere

Suport plutitor care se prinde pe placa de surf și ține camera deasupra apei. Go with the flow.Floatable and sink-proof design. Ride the waves knowing your camera is safe, even if it gets knocked off.Double locked.Ultra-strong 3M™ Dual Lock™ Reclosable Fastener to keep it securely in place. Easy to attach and remove.Made for the long haul.High-strength, water-resistant 3M™ adhesive base that can handle a wipeout. Compatibilitate: ONE X, ONE R, ONE X2, GO 2, ONE RS (Twin/4K), X3, GO 3, Insta360 Ace Pro, Insta360 Ace, X4, GO 3S, Insta360 Ace Pro 2, X5, GO Ultra Note de utilizareThe Sticky Base is highly adhesive and may be difficult to remove from the surfboard. It cannot be reapplied after being removed. Do not remove it after surfing; simply leave it on the board.If you wish to remove the Sticky Base, use a hair dryer to soften the adhesive and peel it away from the edge of the base. Do not use sharp objects to remove it to avoid damaging your surfboard.When shooting with GO 3/GO 3S, install it onto the Floating Surfboard Mount with the GO 3/GO 3S Vertical & Horizontal Action Mount Set. Do not use the GO 3/GO 3S Quick Release Mount, or the camera may fall off.Do not install GO 3/GO 3S with the Action Pod, as it may affect the waterproofing. Install the GO 3/GO 3S Dive Case first if you use the Action Pod.The GO 3/GO 3S Vertical & Horizontal Action Mount Set and Dive Case are not included in the box, and they can be purchased separately.Store the Floating Surfboard Mount in temperatures between 50ºF to 140ºF (-10ºC to 60ºC) with humidity less than 90%. Avoid overexposure to the sun, as this may weaken the adhesiveness.Selfie sticks are not compatible with this mount as they may cause the camera to fall off.The Tri-Float can prevent your camera from sinking. If it falls off, the mount will float on the sea or wash ashore with your camera attached.If the Silicone Mount or Tri-Float are washed off, reattach them to continue using.When surfing but not using the camera, remove the Silicone Mount from the Sticky Base or insert a Thumb Screw onto the Silicone Mount to prevent it from falling off.It is not recommended for use with the Insta360 X3 or X4 Utility Frame.To enhance camera stability, use the X4 Vertical-Horizontal Mount with the Floating Surfboard Mount and mount X4 horizontally to lower the center of gravity. You can also use the Quick Release Mount to quickly switch between horizontal and vertical mounting. Tutorial video de instalareBrowserul tău nu suportă redarea video.