Suport auto cu ventuze electrice Insta360 Triple Electric Suction Cup Car Mount

Description

Suport auto cu trei ventuze electrice, care se fixează și se eliberează la apăsarea unui buton. New angles made easy.Break free from traditional mounts and capture bold, dynamic third-person driving shots.Locked in, every time.Upgraded design that locks instantly with one press. Built-in sensors continuously monitor suction so your rig maintains maximum grip at all times. Long-lasting battery offers up to 120 hours* of power with up to 5 days of suction on a full charge—ideal for road trips.Engineered for the extremes.Made with high-strength materials and a durable 18mm carbon fiber support rod, it stays steady through rough roads, high speeds, and tough weather.Fits any setup.Easily mounts to a wide range of vehicle types and positions. Nail any angle from your roof, hood or trunk.Flexible by design.Switch between a triple, dual, or single cup setup. Mix and match to capture every angle your adventure demands. Compatibilitate: EVO, ONE, GO, ONE X, ONE R, ONE X2, GO 2, Pro, Pro 2, Titan, ONE RS (Twin/4K), ONE RS 1-Inch 360 Edition, ONE RS, Sphere, Link, X3, Flow, GO 3, Insta360 Ace Pro, Insta360 Ace, X4, GO 3S, Flow Pro, Insta360 Link 2, Insta360 Link 2C, Insta360 Ace Pro 2, Insta360 Connect, Flow 2 Series, X5, GO Ultra, X4 Air, Wave, Link 2C Pro, Link 2 Pro, Mic Pro, Luna Ultra, Snap, X6 Note de utilizareThe Insta360 Triple/Dual Electric Suction Cup Car Mount is only compatible with the Insta360 Action Invisible Selfie Stick. Do not use with other selfie sticks.When using the Triple Electric Suction Cup Car Mount, try to install all three suction cups on the same surface. If this is not possible, the suction cups on either side of the horizontal support rod must be on the same surface, and the suction cup on the expansion support rod must be installed on another suitable surface.After installing the mount, ensure all the knobs are fully tightened. If a knob cannot be tightened, or if the NATO rail mount, expansion support rod, or selfie stick remain loose even after tightening, do not use the mount.The suction cups are modular. When used individually, they do not support installing a selfie stick.Do not drop, hit, or throw the mount to avoid damage.Do not use the mount in the rain.Do not expose the product to grease or chemical solvents for a long period, as this may weaken the suction.Before installing the mount, ensure that the surface of the car or area is smooth and clean.Before starting suction, press the mount fully against the surface and adjust the angle if needed.Keep the white filter cotton at the bottom of the suction cup to prevent sand or dirt from entering.When not charging, keep the USB-C port's silicone plug sealed to prevent water or dust from entering.Clean the suction cup after use to maintain suction power.When attached to a vehicle, check the battery level while the vehicle is parked. If the battery is below 10%, remove and charge fully before using it again. It is suggested to gently shake the suction cup every 6 hours to ensure it remains secure.If the mount is not used for a long time (e.g., 3 months), recharge the battery.Please assemble and use the mount according to the instructions and do not use it with any other accessories. If malfunction or damage is caused by failure to follow the instructions in this document, the warranty will be void.We recommend using this product at altitudes below 4,000m (13,123ft).If the suction cup repeatedly re-evacuates air, check your current altitude. If it exceeds the recommended operating altitude, stop using the product.